TM 9-2320-209-20-3-3 18-75. VAN DOOR ASSEMBLY REMOVAL AND REPLACEMENT (TRUCKS M109A2, M109A3, M185A2, AND M185A3). TOOLS: NOTE This task is the same for the right and left rear van door assemblies. This task is shown for the right rear van door. 3/8-inch drive socket wrench set Flat-tip screwdriver 1/2-inch wrench 1/2-inch socket wrench Hoist sling 6-inch extension Hoist equipment, 2-ton capacity 10-foot stepladder SUPPLIES: None PERSONNEL: One EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. Preliminary Procedure. If left rear door is being taken off, remove ladder. Refer to TM 9-2320-209-10. b. Removal. 1. Working inside truck, using screwdriver, unscrew and take out two screws (1). Pull door check (2) away from door (3). Open door partway. GO TO FRAME 2 18-397