TM 9-2320-209-20-3-3 FRAME 2 1. 2. 3. Put rear discharge lever (1) in forward (off) position. Using pliers, pull cable (2) through hole in bolt (3) until all slack is out of cable. CAUTION Do not put any tension on cable (2) when tightening nut (4). Using 1/2-inch wrench, tighten nut (4). NOTE Follow-on Maintenance Action Required: 1. Lubricate tubes. Refer to LO 9-2320-209-12/1. 2. Refer to discharge valve replacement, para 18-53, for replacement of bottom cover plate under tank section of chassis. END OF TASK 18-285