TM 9-2320-209-20-3-3 FRAME 2 Soldier A 1. Hold yoke (1) on wood block as shown. NOTE Drive pin punch must be a little smaller than end of journal (2) so punch can go through bore of bearing. Soldier B 2. Using hammer and drive pin punch, hammer end of journal (2) down into yoke (1). Bearing (3) will come out at bottom of yoke. Soldier A 3. Turn yoke (1) over. Soldier B 4. Do step 2 again for other bearing (3). When bearing falls out, take spider (4) out of yoke (1) by letting one end down into hole where bearing was. Take out other end first. GO TO FRAME 3 18-168