TM 9-2320-209-20-3-2 FRAME 3 1. Using 7/16-inch wrench, loosen screw (1) just enough so that fluid line connector (2) can be turned. 2. Turn fluid connector (2) so that screw hole in bottom lines up with hydraulic line fitting (3). 3. By hand, screw hydraulic line fitting (3) into fluid line connector (2). 4. Using 7/16-inch wrench, tighten screw (1). 5. Using 7/16-inch wrench, tighten hydraulic line fitting (3). 1. 2. END OF TASK NOTE Follow-on Maintenance Action Required: Replace hub and brake drum assembly. Refer to para 14-4. Bleed wheel cylinder. Refer to para 13-15 and 13-16. 13-77