TM 9-2320-209-20-3-2 FRAME 2 1. Put ends of two upper torque rods (1 and 2) into holes in bracket (3). 2. Put other end of torque rod (1) into holes in bracket (4) on forward-rear axle. Put other end of torque rod (2) in bracket (4) on rear-rear axle. 3. Using sledge hammer, tap four ends of torque rods (1 and 2) into brackets (3 and 4). 4. Using 1 7/16-inch socket wrench, screw on two lockwashers (5) and nuts (6), and two lockwashers (7) and nuts (8). 5. Using torque wrench with 1 7/16-inch socket, tighten two nuts (6) to 350 to 400 pound-feet. 6. Using torque wrench with 1 7/16-inch crow foot adapter, tighten nut (8) to 350 to 400 pound-feet. GO TO FRAME 3 17-67