TM 9-2320-209-20-3-2 1. 2. 3. Put saddle (1) onto spring (2). Make sure saddle is down on spring. Put U- bolts (3) over saddle and down into spring seat (4). Screw on four lockwashers (5) and nuts (6) to U-bolts (3). Using torque wrench, tighten four nuts (6) to 180 to 230 pound-feet. NOTE Follow-on Maintenance Action Required: 1. Replace rear wheels. Refer to TM 9-2320-209-10. 2. Lower and take away jacks under cross shaft and rear axle housings. Refer to para 11-3. 3. Remove chocks from front wheels. END OF TASK 17-56