TM 9-2320-209-20-3-2 17-10. REAR SPRING SEAT WITH BEARINGS REMOVAL AND REPLACEMENT. TOOLS: 1/2-inch wrench Brass punch 1 1/16-inch wrench Jack (2) Torque wrench, 600 pound- Wheel bearing remover and replacer, feet capacity pn 7082863 Flat-tip screwdriver Oil seal replacer, pn C-10937827 Needle nose pliers Jack stand (2) SUPPLIES: Cover gasket Nut lock Artillery and automotive grease, type GAA, MIL-G-10924 Rag PERSONNEL: One EQUIPMENT CONDITION: Truck parked, engine off, handbrake set, front wheels chocked. a. Preliminary Procedures. (1) Jack up and support rear axle housings. Refer to Part 1, para 11-3. (2) Remove rear wheels. Refer to TM 9-2320-209-10. (3) Put jack under cross shaft and support it. b. Removal. 1. Using 1/2-inch wrench, unscrew and take out six screws (1) and lockwashers (2). 2. Take off cover (3) and gasket (4). Throw away gasket. GO TO FRAME 2 17-49