TM 9-2320-209-20-3-2 c. Assembly. FRAME 1 1. 2. 3. 4. 5. 6. Using finger, put thin film of grease in bore of spring seat (1) where bearing cups (2) will go. Put spring seat on plywood (3) to keep spring seat from getting damaged. Put bearing cup (2) on bore in spring seat (1) with thin edge of bearing cup facing up. Put remover and replacer tool (4) in bearing cup (2). Spread open remover and replacer tool and turn screw (5) all the way in. Using hammer, hammer on screw (5) until bearing cup (2) is seated. Turn spring seat (1) over so bearing cup (2) is down. Do steps 1 through 4 again on other bearing cup. NOTE Follow-on Maintenance Action Required: Put rear spring seat back on truck. Refer to para 17-8. END OF TASK 17-48