TM 9-2320-209-20-3-2 b. Disassembly. FRAME 1 1. 2. 3. 4. 5. 6. 7. Push both halves of remover and replacer tool (1) together so there is no space between them. Put remover and replacer tool (1) inside bore of spring seat (2) so it is on top of lower bearing cup (3). Pry remover and replacer tool open. Turn screw (4) all the way into remover and replacer tool (1). Put spring seat (2) on plywood (5) so bearing cup (3) will come down into hole in ply- wood. Using hammer, hammer on screw (4) to drive out bearing cup (3). Lift up spring seat (2) so screw (4) falls out. Take out and throw away bearing cup. Unscrew screw (4) from remover and replacer tool (1). Turn spring seat (2) over so other bearing cup is down. Do steps 1 through 4 again on other bearing cup. WARNING Dry cleaning solvent is flammable. Do not use near an open flame. Keep a fire extinguisher nearby when solvent is used. Use only in well-ventilated places. Failure to do this may result in injury to personnel and damage to equipment. Clean all parts in solvent and dry them. Check all parts for damage or wear, and get new parts for ones that are damaged or worn. END OF TASK 17-47