TM 9-2320-209-20-3-2 d. Assembly. FRAME 1 1. If spring eye sleeve bearings (1) or shackle pin sleeve bearing (2) were taken out, using arbor press, press in new ones. 2. Put long clip (3) on plate (4) and aline holes. Put rivet (5) through clip and plate. 3. Place plate (4), clip (3), and rivet (5) on hard surface with rivet head down. 4. Using hammer and center punch, spread and peen end of rivet (5) into taper- ed hole in plate (4). 5. Do steps 2, 3, and 4 again to put long clip (6) on other end of plate (4). 6. Do steps 2, 3, and 4 again to put short clips (7 and 8) on ends of plate (9). GO TO FRAME 2 17-21