TM 9-2320-209-20-3-2 c. Assembly. 1. 2. 3. 4. 5. Check all parts. Throw away any damaged parts and put new parts in their place. Lift up and hold pawl (1) out of the way. Put shaft (2) through housing (3) and bracket (4). Let go of pawl. Put cotter pin (5) through hole in end of shaft (2). Using pliers, bend open ends of cotter pin. WARNING Always wear leather gloves when handling cable. Do not let cable run through hands. Broken or rusty wires can cause serious injury to personnel. Put one end of cable (6) through each hole in shaft (2). Hold both ends of cable together so they are even when pulled. Pull them until they are through shaft. Put both ends of cable (6) down through opening (7) in bottom of housing (3). GO TO FRAME 2 16-23