TM 9-2320-209-20-3-2 16-6. PINTLE HOOK REPAIR. TOOLS: Pliers Center punch 1 1/2-inch wrench (2) Anvil Drift punch Vise Hammer SUPPLIES: Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680 Artillery and automotive grease, type GAA, MIL-G-10924 PERSONNEL: Two EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. a. Preliminary Procedure. Take pintle hook off truck. Refer to para b . Disassembly. FRAME 1 16-5. 1. Put pintle hook (1) in vise. 2. Using pliers, take out cotter pin (2). 3. Using wrenches, hold bolt (3) and unscrew and take off nut (4). Take out bolt. 4. Take pintle hook (1) out of vise and put latch (5) into vise. 5. Using hammer, tap off lock (6) from pintle hook (1). 6. Using hammer and drift punch, drive out pin (7). 7. Take lock (6) off latch (5). Spring (8) will stay on latch. Take off spring. 8. Take latch (5) out of vise. IF WORKING ON PINTLE WITH TEFLON BUSHINGS, GO TO FRAME 2. IF WORKING ON PINTLE WITH GREASE FITTING, END OF TASK 16-12