TM 9-2320-209-20-3-2 FRAME 3 1. 2. 3. GO Put loose end of handbrake cable (1) through hole in frame (2). Put wearplate (3) under handbrake cable (1) so middle of wearplate is on corner of toolbox (4). Put two clamps (5) onto wearplate, lining up screw holes. Put two screws (6) through each clamp (5) and wearplate (3). Using 7/16- inch wrench, screw on and tighten four nuts (7). TO FRAME 4 13-29