TM 9-2320-209-20-3-2 15-8. DRAG LINK ASSEMBLY REPAIR. TOOLS: Six-point 7/16-inch wrench SUPPLIES: Solvent, dry cleaning, type II (SD-20), Fed. Spec P-D-680 PERSONNEL: One EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. 1. 2. 3. 4. NOTE Repair of drag link assembly is limited to the replacement of parts found damaged during inspection. Remove drag link assembly. Refer to para 15-7. All parts except grease fittings are off drag link when drag link assembly is taken out. If grease fittings (1) are bad, using wrench (2). Using wrench, screw in new fittings. , unscrew them from drag link WARNING Dry cleaning solvent is flammable. Do not use near an open flame. Keep a fire extinguisher nearby when sol- vent is used. Use only in well-ventilated places. Fail- ure to do this may result in injury to personnel and damage to equipment. Using solvent, clean all parts. Check all parts. Throw away bad parts and get new parts in their place. Replace drag link assembly. Refer to para 15-7. END OF TASK 15-29