TM 9-2320-209-20-3-2 FRAME 4 1. 2. 3. 4. 5. Lubricate drag link. Refer to LO 9-2320-209-12/1. Using screwdriver bit, screw in and tighten adjusting plug (1). Unscrew adjusting plug one half turn or less, until cotter pin slot lines up with holes. Put cotter pin (2) through drag link (3). Using pliers, open ends of cotter pin. Go to pitman arm (4) end of drag link (3). Do steps 2 and 3 again on that end of drag link. Take safety jacks away. Jack truck chassis down. Refer to Part 1, para 11-4. END OF TASK 15-28