TM 9-2320-209-20-3-2 FRAME 2 1. 2. 3. 4. 5. 6. 7. Jack up tie rod (1) as close to steering knuckle (2) as possible. Put tie rod end (3) into steering knuckle (2). Using 1 3/8-inch wrench, screw on nut (4) all the way. Put cotter pin (5) through nut (4) and tie rod end (3). If cotter pin holes are not lined up, unscrew nut only until they do. Using pliers, bend ends of cotter pin (5) around nut (4). Using 15/16-inch wrench, tighten two nuts (6). Take jack away from tie rod (1). NOTE Follow-on Maintenance Action Required: Adjust toe-in. Refer to para 15-3. END OF TASK 15-21