TM 9-2320-209-20-3-2 d. Replacement of Overcenter Locking Handbrake Lever Cable. FRAME 1 1. 2. 3. 4. Find end that end CAUTION Be careful when putting in handbrake cable (1) so that there are no sharp bends or kinks. of handbrake cable (1) that has yoke (2) and groove (3) on it. Put of handbrake cable up through hole in bottom of bracket (4). Put spacer (5) between groove (3) on cable (1) and bracket (4). Put clamp (6) over groove. Line up screw holes in spacer, clamp, and bracket. Put two screws (7) through clamp (6), spacer (5), and bracket (4). Using 9/16-inch wrenches, screw on and tighten two nuts (8). Put bracket (4) under cab of truck from the rear and put four studs (9) through four holes in floorboard under handbrake lever. GO TO FRAME 2 13-27