TM 9-2320-209-20-3-2 14-11. REAR WHEEL BEARING CONES AND SEALS REMOVAL AND REPLACEMENT FOR SERVICE. TOOLS: Oil seal replacer, C10937827 3/4 x 10-inch brass drift SUPPLIES: Artillery and automotive grease, type GAA, MIL-G-10924 Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680 Clean rags Rear wheel bearing inner seal PERSONNEL: One EQUIPMENT CONDITION: Truck parked on level ground, engine off, handbrake set. a. Preliminary Procedure. Remove rear wheels and brake drum assembly. Refer to para 14-8. b. Removal. NOTE Outer wheel bearing cone and seal are taken out during removal of rear wheels and brake drum assembly. 1. Using puller, pull bearing (1) off wheel hub spindle (2). 2. Using hammer and brass drift, tap and slide off seal (3). Throw away seal. END OF TASK 14-73