14-9. REAR TOOLS: TM 9-2320-209-20-3-2 HUB AND BRAKE DRUM ASSEMBLY REMOVAL AND REPLACEMENT. 3/4-inch wrench 3/4-inch socket wrench Wheel bearing nut wrench, pn 7076869 10-inch socket handle Torque wrench, 150 pound-feet capacity 8-ounce ballpeen hammer 1/4-inch pin punch Brass drift pin punch Portable bearing lubricator Hand grease gun SUPPLIES: Drive flange gasket Artillery and automotive grease, type GAA, MIL-G-10924 PERSONNEL: Two EQUIPMENT CONDITION: Truck parked on level ground, engine off, handbrake set. a. Preliminary Procedure. Remove rear wheel. Refer to TM 9-2320-209-10. b. Removal. 1. Using 3/4-inch wrench, unscrew and take off eight capscrews and eight lockwashers (1). 2. Take out axle shaft assembly (2) and gasket (3). Throw away gasket (3). GO TO FRAME 2 14-55