TM 9-2320-209-20-3-2 14-7. FRONT INNER AND OUTER WHEEL BEARINGS AND SEALS REMOVAL AND REPLACEMENT. TOOLS: Portable bearing lubricator Hand grease gun Ballpeen hammer 3/4 x 10-inch brass drift Prybar SUPPLIES: Artillery and automotive grease, type GAA, MIL-G-10924 Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680 Clean rags PERSONNEL: One EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. a. Preliminary Procedure. Remove front hub and brake drum assembly. Refer to para 14-4. b. Removal. NOTE Outer wheel bearing cone is removed during front hub and drum assembly removal. 1. Using prybar, pry bearing (1) off wheel hub spindle (2). 2. Using prybar, pry and slide off seal (3). Throw away seal. GO TO FRAME 2 14-37