TM 9-2320-209-20-3-2 13-4. HANDBRAKE BRAKESHOES REMOVAL AND REPLACEMENT. TOOLS: 5/8-inch wrench 3/4-inch wrench 11/16-inch wrench 1 7/16-inch wrench 5/16-inch wrench 1 5/16-inch wrench 7/16-inch wrench Flat-tip screwdriver 6-inch ruler Pliers SUPPLIES: Spacers (as needed) PERSONNEL: One EQUIPMENT CONDITION: Truck parked, engine off, front wheels chocked, handbrake released. a. Removal. NOTE On trucks with exhaust pipe going to rear of truck, pipe must be loosened and pushed away from brakeshoes. For trucks with engine LD-427, refer to Part 1, para 5-5. For trucks with engine LD-465, refer to Part 1, para 5–3. For all other trucks, refer to Part 1, para 5-4. FRAME 1 1. Using 11/16-inch wrench, loosen jamnut (1). Using 5/8-inch wrench, back off adjusting screw (2). Lift spring (3) off screw (2) and unhook it. 2. Using 7/16-inch wrench, unscrew and take out grease fitting (4). 3. Using 5/16-inch wrench, hold nut (5). Using 3/4-inch wrench, unscrew and take off nut (6). Pull lever (7) off cable end (8). 4. Take off spring (9) from lever (7). GO TO FRAME 2 13-10