TM 9-2320-209-20-3-2 FRAME 3 1. 2. 3. 4. 5. Pass end of handbrake cable (1) through eye of lever assembly (2). Screw nut (3) two turns onto end of handbrake cable (1). Using adjustable wrench, hold cable (1). Using 3/4-inch wrench, screw on nut (3) until 1/4inch of handbrake cable comes through nut. Hook spring (4) over adjusting screw (5). Using pliers, hook spring (6) into hole in lever assembly (2). NOTE On trucks with exhaust pipe going to rear, exhaust pipe must be put back in place and tightened. For trucks with engine LD 427, refer to Part 1, para 5-5. For trucks with engine LD 465, refer to Part 1, para 5-3. For all other trucks, refer to Part 1, para 5-4. GO TO FRAME 4 13-8