TM 9-2320-209-20-3-2 FRAME 2 1. Put lever assembly (1) with brakeshoes (2) onto handbrake brake drum (3). 2. Put anchor screw (4) through outer brakeshoe (2). Put on spacer washer (5) and screw anchor screw into bracket (6). 3. Using 6-inch ruler, check that brakeshoe (2) is flush with handbrake brake drum (3) within 1/16inch. If brakeshoe is not within limit given, add spacer washer(s) (5). 4. Screw jamnut (7) onto anchor screw (4). NOTE Do not tighten anchor screw (4) too tightly. Make sure brakeshoes (2) do not bind. 5. Using 1 15/16-inch wrench, screw in anchor screw (4). 6. Using 1 7/16-inch wrench, tighten jamnut (7). GO TO FRAME 3 13-7