TM 9-2320-209-20-3-2 FRAME 2 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. Using pliers, take out spring (1) from clevis pin (2). Take out cotter pin (3). Using 1-inch wrench, hold rod (4). Using 7/8-inch wrench, unscrew jamnut (5) partway. Take out clevis pin (2). Take rod end yoke (6) away from brake pedal lever (7). If less free play is needed, unscrew rod end yoke (6) out a few turns. If more free play is needed, screw rod end yoke in a few turns. Put rod end yoke (6) onto brake pedal lever (7). Line up holes and put clevis pin (2) through rod end yoke. Using 7/8-inch wrench, tighten jamnut (5). Hold 6-inch ruler to floorboard (8) and measure down to screw head (9). Using hand, pull brake pedal lever (7) until free play is used up. Using 6-inch ruler, measure distance to screw head. If screw head (9) moved down 1/4 inch to 1/2 inch, go to step 10. If screw head did not move down 1/4 to 1/2 inch, do steps 2 through 8 again. Put cotter pin (3) in clevis pin (2). Using pliers, spread cotter pin ends. Put spring (1) in clevis pin (2). END OF TASK 13-147