TM 9-2320-209-20-3-2 (b) Multiple tee fitting CAUTION Fittings are made of soft brass. They can be stripped very easily if tightened too much. Tighten fittings just enough to stop fluid from leaking. NOTE Multiple tee fitting on brake hydraulic line on the rear axle is used for this typical procedure. FRAME 1 1. Put multiple tee fitting (1) into place and aline screw holes. 2. Using 9/16-inch open end wrench, put in and hold capscrew (2). Using 9/16-inch open end wrench, screw on and tighten self-locking nut (3). 3. Using 7/8-inch open end wrench, hold multiple tee fitting (1). Using 7/16-inch combination box and open end box wrench, screw on and tighten two tube nuts (4). GO TO FRAME 2 13-104