TM 9-2320-209-20-3-1 b. Replacement. FRAME 1 1. 2. 3. 4. NOTE When boot is properly installed, the zipper will be to the front when on left wheel and to the rear when on right wheel. Turn boot (1) inside out so tab on zipper (2) is on the outside. Put boot around axle (3) so small end is at steering knuckle (4). Close zipper (2) all the way. Using cement (part of kit), seal all along zipper so it will not leak. Hold boot (1) so the word TOP on boot is at highest point. Push boot onto axle housing (5) so boot clamp groove goes into axle housing clamp groove. Put clamp (6) onto boot (1) clamp groove. Using 11/32-inch wrench, hold nut (7). Using screwdriver, tighten screw (8). Make sure clamp fits all the way around. GO TO FRAME 2 11-22