TM 9-2320-209-20-3-1 e. Adjustment. FRAME 1 1. 2. 3. 4. 5. 6. 7. NOTE Refer to para 3-3d of clutch control and linkages replace- ment procedure to check free pedal travel. Using 3/4-inch wrenches, hold clevis (1) and loosen nut (2) . Pull pin (3) to one side of clevis (1). Pull clevis away from throwout shaft lever ( 4). If free pedal travel is less than 1 1/2 inches, shorten length of rod (5) by screwing clevis ( 1) into rod. If free pedal travel is more than 2 inches, make length of rod (5) longer by unscrewing clevis ( 1). After setting length of rod (5) , join clevis (1) to throwout shaft lever (4) . Using prybar, pry pin (3) (from transmission side) through clevis until pin is seated. Recheck free pedal travel. If free pedal travel is 1 1/2 to 2 inches, using 3/4-inch wrench, tighten nut (2) against clevis (1) . END OF TASK TA 047266 3-15/(3-16 blank)