TM 9-2320-209-20-3-1 FRAME 4 1. Put hydraulic brake line (1) in place on brake assembly (2) and aline holes. 2. Put screw (3) and two washers (4) in place as shown. Using 3/4-inch wrench, screw in and tighten screw. NOTE Follow-on Maintenance Action Required: 1. Replace brake drum and hub. Refer to Part 2, para 14-4. 2. Jack up front of truck, take out supports, and lower front of truck. Refer to para 11-3. 3. Bleed brakes. Refer to Part 2, para 13-15 and 13-16. 4. Remove rear wheels chocks. END OF TASK 11-17