TM 9-2320-209-20-3-1 1. 2. 3. 4. Turn spindle assembly (1) until key slot (2) is at top. Aline holes and seat it firmly over 12 studs (3). CAUTION When putting on brake plate assembly (4), be careful not to damage hydraulic lines. Put brake plate assembly (4) on spindle assembly (1) as shown. Aline holes and seat firmly over 12 studs (3). Put dirt deflector (5) on spindle (1) as shown. Aline holes and seat firmly over 12 studs (3). Using 9/16-inch socket wrench, screw on 12 nuts and lockwashers (6) and tighten them evenly. GO TO FRAME 4 11-16