TM 9-2320-209-20-3-1 FRAME 2 1. 2. 3. 4. Using brass punch and hammer, put seal assembly (1) into end of axle housing (2) as shown. Be very careful not putting splined end axle housing (2). CAUTION to damage seal assembly (1) when of axle shaft assembly (3) into Put axle shaft assembly (3) with thrust washers (4) through steering knuckle housing (5) as shown. Guide splined end (6) through axle housing (2) into splined differential side gear inside of housing. Slide spindle assembly (7) onto outer shaft of axle shaft assembly (3). GO TO FRAME 3 11-15