TM 9-2320-209-20-3-1 11-5. FRONT AXLE SHAFT ASSEMBLY REMOVAL AND REPLACEMENT. TOOLS: 9/16-inch socket wrench Seal puller 1-gallon container Brass punch 3/4-inch wrench Hammer SUPPLIES: None PERSONNEL: One EQUIPMENT CONDITION: Truck parked on level surface, engine off, handbrake set, rear wheels chocked. a. Preliminary Procedures. (1) Jack up front of truck and support axle housing. Refer to para 11-3. (2) Remove brake hub and drum. Refer to Part 2, para 14-4. b. Removal. NOTE Removal procedure is the same for left or right front axle shaft assemblies. 1. Put container under brake assembly (1) to catch brake fluid, 2. Using 3/4-inch wrench, unscrew and take out screw (2). Take out two washers (3). 3. Using 9/16-inch socket wrench, unscrew and take off twelve nuts and lockwashers (4). 4. Take off dirt deflector (5). 5. Lift off brake plate assembly (1). GO TO FRAME 2 11-12