TM 9-2320-209-20-3-1 f. Assembly (Bearing Cap Type). 1. Put four retainers (1) and four gaskets (2) on journals (3). 2. Screw grease fitting (4) into spider (5) and tighten, using 5/16-inch wrench. 3. Put spider (5) into flange yoke (6) by tilting spider as necessary. 4. Using fingers, press two holes in yoke (6). 5. Place assembly on a wood each bearing cap (7) into GO TO FRAME 2 bearing caps (7) over two journals (3) through block as shown. Hold spider (5) in place and tap yoke (6), using rawhide mallet. 10-24