e. Assembly (Snapring and C-Ring Type). NOTE This procedure is the same for both TM 9-2320-209-20-3-1 types except where noted. 1. Put four retainers (1) and four gaskets (2) on journals (3). 2. Screw grease fitting (4) into spider (5) and tighten using 5/16-inch wrench. 3. Put spider (5) into flange yoke (6) by tilting spider as necessary. 4. Using fingers, press two bearings (7) over two journals (3) through holes in yoke (6). 5. Place assembly on a wood block as shown. Hold spider (5) in place and tap each bearing (7) into yoke (6) using rawhide mallet. GO TO FRAME 2 10-21