TM 9-2320-209-20-3-1 1. Place one side of yoke (1) on wood block as shown. NOTE Diameter of drift pin punch should be just a little smaller than diameter of bearing. 2. Center drift pin punch (2) on face of top bearing (3) as shown. Tape drift pin punch lightly with hammer until bottom bearing (4) is driven out. 3. Turn yoke (1) over and repeat steps 1 and 2 to drive out other bearing. 4. Tilt spider (5) to one side and lift spider out of yoke (1). GO TO FRAME 3 10-13