TM 9-2320-209-20-3-1 10-5. UNIVERSAL JOINT (SNAPRING, C-RING, AND BEARING REPAIR. TOOLS: Retaining ring pliers Machinist hammer, small 5/16-inch wrench 9/16-inch wrench Flat-tip screwdriver SUPPLIES: Universal joint repair kit Solvent, dry Artillery and Wood block PERSONNEL: One EQUIPMENT CONDITION: cleaning, type II Drift pin punch Rawhide mallet Grease gun CAP TYPE) Fine polishing stone Chisel (SD-2), Fed. Spec P-D-680 automotive grease, type GAA, MIL-G-10924 Universal joint assembly out of truck. a. Disassembly (Snapring and C-Ring Type). NOTE This procedure is the same for except where noted. both types 1. If working on snapring type, using retaining ring pliers, take out four re- taining rings (1). 2. If working on C-ring type, using retaining ring pliers, take out two re- taining rings (2). 3. Using 5/16-inch wrench, unscrew and take out grease fitting (3). GO TO FRAME 2 10-12