TM 9-2320-209-20-3-1 10-4. PROPELLER SHAFT AND UNIVERSAL JOINTS REMOVAL AND REPLACEMENT (ALL EXCEPT INTERMEDIATE PROPELLER SHAFT ON TRUCK M36A2). TOOLS: 3/4-inch wrench SUPPLIES: None PERSONNEL: One EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. a. Removal. WARNING 1. 2. 3. 4. Always jack up one wheel of the axle driven by propeller shaft being removed. This is to keep personnel from being hurt by windup of shaft. NOTE Before taking propeller shaft out, make sure arrow (1) stamped on shaft and sleeve yoke at slip joint can be seen. If not, mark both parts so they can be put to- gether in same position. Using wrench, unscrew four nuts (2) and take off nuts and screws (3). Let end of propeller shaft (4) down slowly. Using wrench, unscrew four nuts (5) and take off nuts and screws (6). Take out propeller shaft (4) with universal joints (7). END OF TASK 10-9