TM 9-2320-209-20-3-1 1. 2. NOTE To aline grooved pin (1) in clevis (2) with hole in reverse shaft lever (3), move shift rod lever (4) forward or backward as necessary. Aline grooved pin (1) with hole in reverse shift lever (3). Using small hammer, tap head of grooved pin (1) until seated in clevis (2). NOTE Follow-on Maintenance Action Required: 1. Do reverse shift linkage check, and if required, do adjustment procedure. Refer to para 9-5 for check. Refer to para 9-6 for adjustment. 2. Lower front wheel and remove jack. Refer to para 11-4. 3. Replace rear and intermediate tunnels. Refer to Part 3, para 18-5. END OF TASK 9-44