TM 9-2320-209-20-3-1 1. Push lower end of clutch throwout shaft lever (1) forward until resistance is noted. Using scale, measure distance from center of lever bottom hole to transmission flange as shown. NOTE Measurement should be approximately 3 1/4 inches. 2. If measurement is not approximately 3 1/4 inches, take off lever (1) and turn it one spline at a time until measurement is correct. 3. Using 3/4-inch wrenches, hold bolt (2) and tighten nut (3) . 4. Join rod Locknut 5. Join rod NOTE Before joining rod assembly (4) to control lever (5) , put lever in up position. assembly (4) to control lever (5) with bolt (6) and locknut (7) . must be on transmission side as shown. assemblv (4) to clutch throwout shaft lever (1) using pin (8) . Head “ o - f pin must be on transmission side as shown. Using prybar, pry pin in clevis ( 9) until head of pin seats against clevis. 6. Using 3/4-inch wrenches, tighten locknut (7). Go TO FRAME 4 3-9