TM 9-2320-209-20-3-1 FRAME 4 1. Place rear tunnel (1) over shifting lever (2) and aline tunnel mounting holes with floor holes. 2. Set transfer shifting lever (2) to LOW position with 1/4 to 1/2-inch clearance from floor. This distance is measured at point (A) as shown. 3. Using ruler, measure distance from top of transfer shifting lever (2) to top of crossbrace (3) as shown. 4. Take rear tunnel (1) out of cab. 5. Using ruler, set transfer shifting lever (2) to same distance from crossbrace (3) as it was in step 3. GO TO FRAME 5 9-38