TM 9-2320-209-20-3-1 9-4. TRANSMISSION TRANSFER CONTROLS AND LINKAGE (WITHOUT POWER TAKEOFF) REMOVAL, REPAIR, AND REPLACEMENT. NOTE Procedures given are the same for both air actuated positive lockup transmission transfer and transmission transfer without air actuated positive lockup, except where noted. TOOLS: 3/8-inch wrench 7/16-inch wrench 9/16-inch wrench (2) 3/4-inch wrench (2) 3/4-inch socket wrench clamp Vise grip pliers Wood blocks 8-inch extension Vise Ruler Rolling head prybar 9/16-inch socket wrench Small hammer Jack Retaining ring pliers SUPPLIES: Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680 PERSONNEL: TWO EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. On transmission positive lockup, or reverse shift CAUTION transfers without air actuated removal of transmission transfer linkage requires complete adjustment of reverse-shift linkage. This is to make sure that double sprag overrunning clutch works correctly. Refer to para 9-6. a. Preliminary Procedures. Remove cab tunnels. Refer to Part 3, para 18-5. 9-24