TM 9-2320-209-20-3-1 FRAME 5 1. 2. 3. 4. 5. IF Push lockout arm (1) up until shoulder bolt (2) is firmly seated at bottom of slot in lockout arm, locking transfer in neutral. While holding lockout arm (1) up, check alinement of holes in clevis (3) with hole in lockout shaft lever (4). If holes do not line up, do steps 4 and 5 to shorten or lengthen control rod (5). Using 5/8-inch wrench, loosen jamnut (6). Screw control rod (5) into clevis (7) to shorten control rod. Unscrew control rod (5) from clevis (7) to make control rod longer. CONTROL ROD (5) CANNOT BE MADE LONG ENOUGH TO ALINE HOLES, GO TO FRAME 6. IF CONTROL ROD (5) CAN BE ADJUSTED TO ALINE HOLES, GO TO FRAME 7 9-20