TM 9-2320-209-20-3-1 c. Repair. Repair clutch control and linkages by welding, straightening or replacing any broken or damaged parts. Refer to TM 9-237. d. Replacement. 1. Put pedal lever shaft (1) through brake lever assembly (2) and then through shaft support ( 3) as shown. 2. Put woodruff key (4) in slot at end of pedal lever shaft ( 1). 3. Put control lever (5) on end of pedal lever shaft (1) . Pedal lever slot must aline with key (4) on shaft. End of control lever should be flush with shaft. 4. Using 9/16-inch wrenches, tighten locknut (6) while holding bolt ( 7). GO TO FRAME 2 TA 047258 3-7