TM 9-2320-209-20-3-1 Soldier A Soldier B Soldier A Soldier B 1. 2. 3. 4. Put dimmer switch plunger (1) through hole in floor (2) and position dimmer switch (3) as shown. Aline two holes in mounting flange (4) with holes in floor. Tell soldier A when mounting holes are alined. Screw in two screws (5) with starwashers (6) but do not tighten screws. Put protective cover (7) over dimmer switch side (8) between flange (4) and floor (2) so screws (5). Tell soldier B when cover is in Using screwdriver, tighten two screws (5). (3). Slide slotted slots are around position. NOTE Follow-on Maintenance Action Required: 1. Close hood and left side panel. Refer to TM 9-2320-209-10. 2. Replace battery ground cable. Refer to para 7-58. 3. Check operation of headlight dimmer switch. Refer to TM 9-2320-209-10. END OF TASK 7-253