TM 9-2320-209-20-3-1 Section X. MISCELLANEOUS ITEMS 7-63. DIRECTIONAL SIGNAL AND SOLID STATE FLASHER REMOVAL, REPAIR, AND REPLACEMENT. TOOLS: Flat-tip screwdriver Drill 3/8-inch wrench (2) Finely pointed awl No. 6-32 NC tap (4) Round head machine screws (4) No. 36 drill bit Self-tapping screws No. 28 drill bit SUPPLIES: None PERSONNEL: TWO EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. a. Preliminary Procedures. (1) Disconnect battery ground cable. Refer to para 7-58. (2) Open hood and left side panel. Refer to TM 9-2320-209-10. b. Removal. (1) Directional signal. 1. Unscrew and take off connector (1). 2. Using screwdriver, unscrew screw (2) to loosen clamp (3). 3. Pull open clamp (3) and take off directional signal (4). END OF TASK 7-242