TM 9-2320-209-20-3-1 CHAPTER CLUTCH SYSTEM GROUP 3 MAINTENANCE Section I. SCOPE 3-1. EQUIPMENT ITEMS COVERED. This chapter gives equipment maintenance pro- cedures for the clutch linkage assembly for which there are authorized corrective maintenance tasks at the organizational maintenance level. 3-2. EQUIPMENT ITEMS NOT COVERED . All equipment items for which corrective maintenance is authorized at the organizational maintenance level are covered in this chapter. Section II. CLUTCH LINKAGE ASSEMBLY 3-3. CLUTCH CONTROL AND LINKAGE REMOVAL , REPAIR, REPLACEMENT, AND ADJUSTMENT . TOOLS : Prybar 6-inch ruler 9/16-inch wrench (2) Drift pin punch 3/4-inch wrench (2) Pliers Flat-tip screwdriver SUPPLIES : Chalk, SS-C-266F PERSONNEL : One EQUIPMENT CONDITION : Truck parked, engine off, handbrake set, wheels chocked. a. Preliminary Procedures. (1) Take off accelerator linkage. Refer to para 4-29. (2) On trucks with transmission power takeoff, tell direct support mainte- nance to take off power takeoff. 3-1