TM 9-2320-209-20-3-1 Section IX. CHASSIS HARNESS 7-59. GENERATOR-TO-REGULATOR HARNESS REMOVAL, REPAIR, AND REPLACE- MENT (TRUCKS WITH ENGINES LDS 427-2, LD 465-1, AND LDT 465-IC). TOOLS: Spanner wrench Soldering iron SUPPLIES: Sandpaper or crocus cloth Electric insulating tape, MIL-T-50886 PERSONNEL: One EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. a. Preliminary Procedure. Disconnect battery ground cable. Refer to para 7-58. b. Removal. FRAME 1 NOTE Note the way generator-to-regulator harness is routed so that it can be put back the same way. 1. Using spanner wrench, unscrew and take off generator–to–regulator harness connector (1) from regulator (2). 2. Using spanner wrench, unscrew and take off generator–to–regulator harness connector (3) from generator (4). 3. Take out generator-to-regulator harness (5). END OF TASK 7-227