TM 9-2320-209-20-3-1 1. 2. 3. 4. 5. 6. 7. 8. 9. NOTE If working on early model trucks, do step 1. Using flat-tip screwdriver, unscrew and take out three screws (1). Take off rim (2). Turn on headlights and high beams. Refer to TM 9-2320-209-10. Cover right headlight. Center of left headlight hot spot (3) should be where lines A-A and B-B meet as shown. Using flat-tip screwdriver, turn screw (4) to move hot spot (3) left or right to put center as shown. Using flat-tip screwdriver, turn screw (5) to move hot spot (3) up or down to put center as shown. Uncover right headlight. Do steps 2 through 6 again for right headlight, covering left headlight and using lines C-C and A-A. Shut off high beams and headlights. Refer to TM 9-2320-209-10. END OF TASK 7-101