TM 9-2320-209-20-3-1 Section III. ENGINE LUBRICATION SYSTEM 2-5. OIL FILTER ELEMENT REMOVAL AND REPLACEMENT. NOTE The following tasks are the same for both oil filters. TOOLS : 7/16-inch open end wrench Drain pan 7/8-inch wrench 7/8-inch socket Torque wrench, 150 pound-feet capacity 6-inch long round nose pliers SUPPLIES : Oil filter kit, NSN 2940-00-884-4801 Lubricating oil, ICE, OE/HDO 10, MIL-L-2104 PERSONNEL : One EQUIPMENT CONDITION : Truck parked, engine off, handbrake set. Preliminary Procedure. Open hood and left side panel. Refer to TM 9-2320-209-10. b. Removal. 1. Place drain pan under engine to catch oil from oil fitting drain plug ( 1). 2. Using 7/16-inch wrench, unscrew and take out drain plug ( 1) and wait until oil stops draining. 3. Check drained oil for water, dirt or pieces of metal. If any of these are found, tell direct support maintenance. GO TO FRAME 2 2-13