TM 9-2320-209-20-3-1 FRAME 3 CAUTION Starter weighs 50 pounds. Be careful not to let it fall when lifting starter into engine compartment. NOTE If starter will not seal firmly against adapter, do not force it. It may be due to gear position. Take starter out, turn starter drive gear slightly, and try again. 1. Put starter (1) in engine compartment. Aline three holes in starter mounting flange (2) with mounting studs (3). Solenoid (4) must be at top as shown. 2. Push starter straight in on mounting studs (3) until it is firmly seated. Put three lockwashers (5) on three mounting studs (3). 3. Screw on and hand tighten three nuts (6) onto three mounting studs (3). 4. Using 15/16-inch socket wrench, evenly tighten three nuts (6). IF PUTTING BACK STARTER, pn 10911018-1, GO TO FRAME 4. IF PUTTING BACK STARTER, pn 10935376-1, GO TO FRAME 5 7-61