TM 9-2320-209-20-3-1 FRAME 2 1. Put starter (1) in position. Aline three holes in starter mounting flange (2) with mounting studs (3). Lever (4) must be at top as shown. NOTE If starter (1) will not seat firmly against adapter, do not force it. It may be due to gear position. Take starter out, turn starter drive gear slightly, and try again. 2. Push starter (1) straight in on mounting studs (3) until it is firmly seated. Put three lockwashers (5) on three mounting studs. 3. Screw on and hand tighten three nuts (6) onto three mounting studs (3). 4. Using 15/16-inch wrench, evenly tighten three nuts (6). GO TO FRAME 3 7-52